1
e
l
e
C
t
r
IC
a
l
s
y
s
t
e
m
s
-
H
o
u
s
e
-
8
LIgHTs
A wide variety of light fixtures and styles
are utilized in the motorhome. The articles
that follow reflect an overview of some of the
more common fixture types. Depending on
floor plan, actual styles may differ from what
is printed.
To Replace a Bulb:
1. Carefully squeeze the lens cover then
gently pull the cover out. The cover
has tabs that lock the cover in place.
2. Using a clean cloth or piece of tissue
carefully grasp the bulb and rotate to
the unlock position.
3. Remove bulb from the socket.
4. The bulb replacement is 1141 12V
21CP.
5. Using a clean cloth or piece of tissue
grasp the new bulb and align the
prongs on the bulb with the slot on
light socket.
6. Push bulb in and rotate to lock
position.
7. Gently squeeze lens cover and insert
tabs on cover into fixture.
INFORMATION
Replacement bulb number is
accurate at time of printing. Confirm
replacement bulb number before
ordering or obtaining a replacement.
CAUTION
DO NOT touch the incandescent bulbs
while it is on. Allow bulb to cool down
before replacing. A hot bulb can cause
a burn.
Interior Halogen
To Remove:
1. Grasp light fixture and pull down
slightly then tilt fixture to one side.
This will allow one spring clip to
come out.
CAUTION
Push spring clip inward with a finger
as clip is being eased out. If this is not
done spring clip can snap back on
fingers.
2. Tilt fixture to other side and ease the
other spring clip out.
3. Unscrew the light lens
counterclockwise and remove.
4. Carefully grasp bulb and pull from
socket. Replace with the same type of
bulb.
5. Use a clean cloth or piece of tissue to
grasp new bulb.
DO NOT
touch bulb
directly as this can cause a “hot spot”
and result in immediate bulb failure.
6. Align contacts of bulb with terminals
in fixture base. Insert bulb until
contacts are firmly seated.
To Reinstall:
7. Align tabs on light lens with slots in
fixture base. Rotate lens clockwise
until light lens locks into place.
8. Fold up both spring clips and insert
light fixture into opening. Once in
opening the spring clips will expand
and lock light fixture into place.
CAUTION
DO NOT touch halogen lighting while
on. They can cause a burn. DO NOT
touch replacement bulbs. Oil in the
hands can cause a “hot-spot” to occur.
If the bulb is touched, allow it to cool
and clean the bulb with alcohol.
080475c
060200d
Summary of Contents for 2011 Aluma Lite
