Holiday 2011 Aluma Lite, Owner'S Manual

Page: 107 / 190

10
e
q
u
Ip
m
e
n
t
-
5
4. Raise the rear arm extension lock
handle all the way up or to the
desired height and lower the lock
handle to lock the arms in place.
5. Repeat instructions 2 through 4 for
the front arm.
Retracting the Awning:
WARNING:
Once the awning brake is placed in the
roll up position, the awning is under
full spring tension. If not firmly held,
the awning will abruptly roll up to
the stored position possibly causing
personal injury or damage to both the
awning and recreational vehicle.
1. Disconnect, remove and/or store any
optional equipment that is used.
2. If applicable, return awning from
carport position.
3. Return inner rafters to travel position.
Tighten locking knob.
4. Lower both outer rafters to stop bolts.
Adjust arm latch pin to engage with
nearest hole then close arm latch.
5. Slide pull strap forward. With one
hand firmly grapsing pull strap,
place awing brake lever to the Roll
Up position. Awning will be under
tension when brake is set to roll up
position.
5. Slide pull strap back to center of
awning. Allow awning to partially
roll up then hook pull strap with pull
rod.
6. Gently allow awning to retract to the
travel position.
7. Squeeze inner and outer rafters
together until rafter travel lock
engages for travel.
Patio Awning - Electric (Optional)
The Eclipse awning operates on 12 Volt DC
by the push of a button. The awning requires
10' of lateral side clearance.
To Operate:
Turn the ignition switch off.
Check for sufficient clearance before
extending the awning.
Chassis battery disconnect must be on.
Turn the awning power On/Off switch
to on.




Push and hold the Extend/Retract
button to extend the awning. Release
the button at any time for partial
extension.
Push the Extend/Retract button and
hold to retract awning.
External Control Switch:
An external control switch is located at the
bottom of the front outside arm.
To Operate:
Turn the ignition switch off.
Check for sufficient clearance before
extending the awning.
Chassis battery disconnect must be on.
Turn the Awning Power On/Off button
to on. Button is located inside the
motorhome on Awning Controls.
Push and hold the external control
switch to extend and retract the
awning. Release the button at any time
for partial extension.







130045
030851f Awning Controls
031243ba
100227