Black plate (63,1)
Holden Volt Owner Manual (Holden-Localizing-Holden-7337564) - 2014 -
CRC - 11/8/13
Vehicle Care
10-63
5. Press the POWER
O
button to
start the Volt. This will wake up
the electronics on the Volt. The
engine will only start if it is
needed.
6. Try to start the other vehicle that
had the run-down battery. If it
will not start after a few tries, it
probably needs service.
Disconnecting the Jumper Cables
1. Disconnect the black negative
(
−
) jumper cable from the other
vehicle that had the run-down
battery. Do not let the other end
of the cable touch anything until
after the next step.
2. Disconnect the black negative
(
−
) jumper cable from the Volt.
3. Disconnect the red positive (+)
jumper cable from the Volt. Do
not let the other end of the cable
touch anything until after the
next step.
4. Disconnect the red positive (+)
jumper cable from the other
vehicle.
5. Return the positive (+) and
negative (
−
) terminal covers to
their original positions.
Towing the Vehicle
{
Caution
Incorrectly towing a disabled
vehicle may cause damage to the
vehicle. The disabled vehicle
should be towed on a flatbed car
carrier. Use care when there is
low ground clearance and/or
special equipment.
Attempting to pull the vehicle onto
a flatbed without following the
proper steps could damage the
vehicle.
Consult your dealer or a
professional towing service if the
disabled vehicle must be towed.
To load a vehicle onto a flatbed
carrier:
1. The vehicle must be on a flat
surface.
