11
Adres producenta/ Adresse des Herstellers/ Manufacturer’s Address/ Адрес производителя
GTV Poland Sp. z o.o. Sp. k., ul. Przejazdowa 21, 05-800 Pruszków
TECHNICAL DATA
Detection function data
Maximum measurement depth*
Ferrous metals 100mm
Non-ferrous metals (Cu) 80mm
Copper wires Cu (≥mm
2
) 40mm
Wood Profiles 20mm/38mm
Moisture range
Metals 0-85%RH
Other materials 0-60%RH
Laser pointer data
Measurement accuracy
±5mm**
Units
m/in/ft
Measuring range (without reflector)
0.05-40m***
Measurement time
0.3-4 seconds
Laser type
620~670nm,<1mw
Automatic laser shutdown
20 seconds
Measurement memory
last 30
General parameters
Automatic shutdown
After 5 minutes
Type of screen
1.8 inch, colour
Type and battery life
400mAH, lithium, approximately 5000 measurements
Dimensions
135*60*25mm
Working temperature range
0 C° ~ 40 C°
Storage temperature range
-20 C° ~ 60 C°
* The detection results are affected by the material, shape and size of the detected object, as well as by the material and condition of
the detected surface; If the cable is not live, the depth of the probe will be reduced.
** Under good measurement conditions (good measuring surface, room temperature) the measurement error may be up
to 0.25 mm/m; under bad measurement conditions (such as too much ambient light, too large or too small a diffuse reflectance of
the point to be measured, too much temperature difference, etc.) the error may be up to ± 10 m.
*** In case of strong daylight or weak target reflection, use a reflector!
NOTE
Do not allow moisture to penetrate the detector and sunlight to fall directly into the device.
Rapid changes in ambient temperature can cause incorrect results.
Using or operating a transmitter, such as a microwave oven near the detector, can affect the results.
For best scan results:
- Avoid jewellery such as rings or watches when using detectors. Metals can cause inaccurate testing.
- Move the tool evenly to the surface without lifting or changing the applied pressure.
- When scanning, tools must always touch the surface.
- Make sure that the fingers of the hand holding the tool do not touch the scanned surface.
- Do not touch the detector or scanned surface with your other hand or any other part of your body.
- Always test slowly for maximum accuracy and sensitivity.