Hog Technologies STRIPE SH7500, Operation Manual

Page: 76 / 187

76
Section 3 - Operation
3.4 Truck & Accessory Hydraulic
System Startup Procedure
The startup procedure outlined in this section is
general and will apply to most trucks. However,
your truck may be slightly different, depending
on the options selected. Always refer to the
placard on the back of the visor in the cab for
specific startup and shutdown instructions
for your truck.
Starting The Truck And Activating Accessory
Hydraulics:
Make sure to complete the Pre-Op checklist prior
to initiating this procedure.
1. Make sure the main breakers are on and all
switches and speed dials are in the OFF posi-
tion or set at 0.
2. Be sure the truck transmission is in “N”, (NEU-
TRAL) position and the park brake is set.
Control Panel and Joystick
Typical Automatic Transmission
START UP/SHUT DOWN PROCEDURE Placard On Visor
3. Start truck engine and allow it to run at idle
speed.
4. Engage the hydraulic PTO. The engagement
switch is on the dash near your right knee.