Hog Technologies STRIPE SH7500, Operation Manual

Page: 113 / 187

113
Section 5 - Scheduled Maintenance
Blower Belt Mounting Bolts & Adjusting Bolt
Important:
Tighten the mount bolts in the slotted holes
and recheck the belt tension and alignment.
Readjust as necessary to achieve correct belt
tension and/or alignment.
5. Start the engine and follow the startup proce-
dure to engage the waterblasting system and
operate the OMSI Drive PTO at idle speed for
30 seconds.
6. Disengage the PTO and return the truck to the
service position.
7. Check that the belt is riding on the center of
the pulleys. If it is not centered and riding
hard on either side of the pulleys, the blower
will have to be aligned by moving the mount
slightly in the slotted bolt holes. Repeat align-
ment and tension steps until the belt is set to
the proper tension and centered on the pul-
leys.
8. Tighten the mounting bolts securely.
Blower Pump Belt Adjustment Bolts Location
A. Slotted Blower Mount Bolts B. Blower Adjustment Bolt
A
A
A
A
B