Hog Technologies PAINT HOG, Operation Manual

Page: 67 / 87

67
Section 4 - General Maintenance
6. Open both paint valves.
7. With the bucket below the drain, allow air to
purge from strainer, then close the drain valve.
Cleaning Paint Filter Strainer
1. Follow the flushing procedure to completely
flush paint from the filter housing and strainer.
2. Once water runs clear, turn off the water valve.
3. Loosen wing nut on the compression clamp
and remove cap and drain valve assembly.
4. Slide the strainer out.
5. Use a hose connected to water system or open
water valve at the filter and hold strainer bas -
ket below the filter housing.
6. Use a soft brush and flowing water to com -
pletely clean the strainer.
7. Close the water valve and insert the basket
8. Install cap and drain valve assembly and make
certain the gasket is in place. Then tighten
compression clamp.
9. With the bucket below the drain, allow air to
purge from strainer, then close the drain valve.
Paint Strainer
Sliding Strainer From Filter Housing