29
11.1-6
11.1-14
F1
11.1-4
F2
Start a new Set of Wheels
After entry of WHEEL No. 5 in a Set, you can start a
new Set, without exiting the Set of Wheels mode.
Proceed as follows:
•
Perform the procedure as described for wheel
No. 1.
The machine deletes the data relative to the previous
wheels and shows the current wheel as the first wheel
in a new Set.
After entry of WHEEL No. 4 in a Set you can start a
new Set, without exiting the Set of Wheels mode.
Proceed as follows:
•
Mount the wheel on the balancer shaft.
•
Perform the run.
•
Complete any normal correction and balancing
operations required.
•
Remove the wheel from the balancer.
Wheel number 5 is shown on the screen page (Fig.
11.1-14).
•
Press key F2 (Fig. 11.1-6).
The machine deletes the data relative to the previous
wheels and shows the last wheel as wheel number 1,
starting a new Set of Wheels.
Terminate and exit procedure
To exit the Set of Wheels procedure and return to the
OPTIMA ENTRY screen page.
•
Press key
F1
(Fig. 11.1-4).
All data relative to the Set of Wheels is deleted.
Summary of Contents for geodyna optima
