14
Operational Selections
geodyna optima
Operator’s Manual
9.2-3
9.2.1-1
9.2.1-2
F1
F2
F3
F4
F5
9.2-2
If no problems are found with the wheel, tire or rim,
the OPTIMA ENTRY screen page shows “OK” (Fig.
9.2-2).
The appearance of the messages is linked to the limit
values set, which the operator can change using the
OPTIMA PARAMETERS
menu (Section 9.6).
(fig. 9.2-3)
F1:
restarts an interrupted matching procedure.
F2:
displays the screen for the advanced rim diagnosis
(see “OPTIMA DIAGNOSIS” section).
F3:
access the preset work parameters in Optima mode
(see “OPTIMA PARAMETERS” section).
F4:
print (if printer is available) or interrupts the current
print (in this case the key is blocked).
F5:
opens the "OPTIMA MATCHING" screen.
9.2.1 Warning Messages in
OPTIMA ENTRY screen
Wheel assembly problems
messages appear when:
1) wheel peak-to-peak
runout
is high
or
2) wheel 1-harmonic
runout
is high and the
proportion of
runout
between rim and tire is
close to 50 per cent.
Alert Message
(Fig. 9.2.1-1)
:
If no
matching
is recommended:
High
runout
on wheel, but no possibility of improving by
matching
. Check rim and tire for defects.
If
matching
is recommended:
High
runout
on wheel. Geometric
matching
is
recommended.
Warning Message
(Fig. 9.2.1-2)
:
Possible issue with wheel, but no possibility of improving
by
matching
. Check rim and tire for defects.
If
matching
is recommended:
Potential problem on the wheel. Check rim and tire for
defects.
Summary of Contents for geodyna optima
