Hoffmann eXess Hand-Held Dovetail Routing Machine
- 11 -
Hoffmann Machine Company, Inc. 1386 Drexel Road Valdese, NC 28690
Phone: (828) 430 - 4510 Fax: (828) 430 - 4620 e-mail: [email protected]
www.Hoffmann-USA.com
X
13.1 Fine Adjustment
The operator can adjust the tightness of an assembled joint as well as the clamping force exerted by the key.
A
LWAYS DISCONNECT THE ELECTRICAL POWER SUPPLY BEFORE ATTEMPTING ANY SERVICE
,
MAINTENANCE OR REPAIR WORK
!
1. Verify that electrical power has been disconnected.
2. Loosen the socket head cap screw in the motor bracket.
3. Carefully slide the motor further toward the bracket to increase the routing depth, or move the motor out of the
bracket to decrease the routing depth.
4. Only a small movement (0.1 – 0.5mm = 0.004 – 0.020”) is necessary to make a noticeable difference.
Increasing the depth will increase the “draw” or pull of the Key, resulting in a tighter joint.
5. Tighten the socket head cap screw – “hand tighten” only.
6. Re-connect the electrical power supply and make a test cut. If the new setting is unsatisfactory, the above
steps are repeated.
Wrong Setting
Correct Setting
14. Factory Settings
Measured from the face of the miter to the bottom of the keyway = dimension X
W-1
3.5mm
=
0.1378”
W-2
5.1mm
=
0.2001”
W-3
6.8mm
=
0.2677”