❏
4. Position the rudder control horn on the right side
of the
rudder
so that it is 3/8" [9.5mm] from the bottom
of the
vertical fin
and at a slight angle downward. Mark
the mounting holes and drill them out with a 5/64"
[2mm] drill bit. Attach the control horn using (2) 2-56 x
1/2" [13mm] screws and a control horn backing plate.
❏
5. Attach the elevator control horn on the left underside
of the
elevator
3/8" [9.5mm] from the fuselage.
❏
1. Cut the
servo tray
and
servo tray supports
from the
1/8" [3mm] plywood sheet.
❏
2. Fit the servo tray supports to the servo tray and glue
them on using medium CA glue.
❏
3. Place your rudder and elevator servos into the
cutout on the servo tray. Mark and drill 1/16" [1.6mm]
holes for the servo mounting screws. Reinforce the
holes with a couple drops of thin CA glue. Install the
servos with the output splines facing forward using the
hardware provided with the servos.
INSTALL THE SERVOS
Correct
Incorrect
9
