❏
1. Locate the two thick and four thin
plywood wing
joiner pieces
. Make two wing joiners by laminating one
thick piece between two thin pieces with 30-minute
epoxy. Clamp the pieces together while the epoxy cures
and use denatured alcohol to wipe away any excess
squeeze out. Make sure the edges of the three joiner
pieces are flush.
❏
2. While waiting for the wing joiner epoxy to cure,
find the exact center of the
center wing section
and
make a mark with a felt tip pen on the trailing edge.
❏
3. Do the same on the
rubber band reinforcement plate
.
❏
4. Place the reinforcement plate on the top of the
center wing section and line up the trailing edges and
the two marks that you made. Trace around the
reinforcement plate.
❏
5. With a new blade in your hobby knife, carefully
cut the covering just inside your line being sure not to
cut into the wood beneath. Pull the covering away and
use alcohol to wipe away the line you drew. Leave the
two marks you made on the trailing edges until after you
have glued the part.
❏
6. Realign the plate on the center wing section and
glue it in place.
ATTACH THE REINFORCEMENT PLATE
MAKE THE JOINERS
ASSEMBLE THE WING
7
