Page.68.
To use the PoE Power Output function, click on the icon and change the switch “ON” or “OFF”.
The IP camera needs to be connected to the LAN port before you turn PoE Power on. If the IP camera
Supports PoE, the PoE power is delivered via pins 1, 2, 3, and 6 on the LAN port. SURVLtest will
display “48V ON” at the top of the screen when the PoE power is still on.
Note:
1. Don’t input power into the “DC12/3A OUTPUT” port.
2. Don’t output DC12V/3A power to the DC12V/IN port of tester in order to avoid tester damaged.
3. The SURVLtest power output is close to 3A, if the IP camera’s power is over 3A, the tester will
auto enter protection mode. Disconnect all the connections of the tester and then connect the tester
with power adaptor to resume the tester.
4. Before turning on the PoE power output, please make sure the IP camera supports PoE power.
Otherwise it may damage the IP camera.
5 Make sure you plug in your IP camera to the LAN port prior to turning on PoE power.
6.
Make sure the tester is full charged or more than 80% charged, otherwise the tester will shows
“low power”, “not able to supply power”.
