HNF-NICOLAI XF3 Adventure, Manual

Page: 76 / 132

76
Measure the SAG at the fork as follows:
• Push back the rubber ring on the fork
• Sit on the XF3 Adventure in riding position and read the SAG on the fork. There
you will find a % scale.
If necessary change the air pressure at the fork until the SAG is within the indicated
range. A recommended air pressure can be found in the table on the left stand tube
(+10 psi) for E-MTB.
• Unscrew the cover cap on the top left of the
fork crown.
• Screw on a shock absorber or suspension
fork pump and read the existing pressure.
• Increase or decrease the pressure to the
pressure determined for you.
• Check the SAG again.
2.5. Charging built-in batteries
The batteries can be charged in the installed sta-
te via the charging socket above the motor.
To do this, remove the rubber cover on the left-
hand side from the charging socket. Insert the
charging cable into the charging socket.
The batteries are charged alternately via the charging socket. Charging time for the
two completely discharged batteries: approx. 9.5 hours.
Both batteries (or optionally only the inserted down tube battery) can be
charged via the charging socket. When the down tube battery is removed,
the top tube battery cannot be charged in the frame alone.
2.6. Removing/inserting the batteries
Always switch off the batteries / the eBike system when inserting the bat-
teries into or removing them from the frame.
Comissioning