HMS ZM1901, Manual Instruction

Page: 21 / 61

9) Remove the Frame Pin (37) from the Rail Bracket (41), and lower the Rail (8) to the floor. Next,
insert the Frame Pin (37) into the Frame
(39) and into the Rail Bracket (41). Then, slide an M13 x 32mm
Washer (88) onto the Frame Knob (87), insert the Frame Knob
into
the Frame (39), and tighten the Frame Knob into the Rail
Bracket (41)
10)
Identify the Stop Rod (35), which is slightly shorter than the
Pedal Axle (not shown).
Insert the Stop Rod (35) into the Frame (39) and center it. Next,
slide a Pedal Stop (34), an M8 x 20mm Washer (16), and an M8
Split Washer (15) onto each side of the Stop Rod (35). Then,
tighten an M8 Acorn Nut (31) onto each end of the Stop Rod (35)
at the same time.
11)
Insert the Pedal Axle (58) into the welded tube on the
Frame (39) and center it. Next, slide a Pedal Spacer (32) and an
M13 x22mm Washer (33) onto each side of the Pedal Axle (58)
(only one side is shown). Next, identify the Right Pedal (30) and
the Left Pedal (57). Slide the Right Pedal onto the right side of
the Pedal Axle (58), and slide the Left
Pedal onto the left side of the Pedal Axle. Next, slide an M8 x
20mm Washer (16) and an M8 Split Washer (15) onto each
side of the Pedal Axle (58) (only one side is shown). Then,
tighten an M8 Acorn Nut (31) onto each end of the Pedal Axle (58) at the same time.
12)
Insert a Pedal Strap (29) through the Right Pedal (30)
as shown. Then, route the end of the Pedal Strap through the
buckle on the Pedal Strap.
Attach the other Pedal Strap (29) to the Left Pedal (57) in the
same way.
13) Attach a Foot Plate (52) to one side of the Front
Stabilizer (50) with a Foot Plate Pin (51). Attach the other
Foot Plate (not shown) to the
other side of the Front Stabilizer (50) in the same way.