Local Configuration
55
Doc.ID. HMSI-168-92
Netbiter EasyConnect
Doc.Rev. 2.10
When logged in to the unit, a status page similar to the following is displayed.
The changes that can be made in these local pages (and then only if required) are for the network and
modem settings. The product firmware can also be updated here, which requires an active connection
to the Internet. Changes made to these other settings will
NOT
be synchronized with the unit settings
existing on Netbiter Argos. Various logs are also supplied for troubleshooting purposes.
10.4.3 Network Settings
These settings apply to connections made via the RJ-45 WAN and LAN ports on the bottom of the unit.
WAN
This interface is the one to enable and use if the Netbiter EasyConnect EC350 will connect to Netbiter
Argos via a wired Ethernet connection.
When DHCP addressing is enbled the unit will automatically receive the settings for IP address, Net-
mask and Gateway. If not using DHCP, these settings must be entered manually, along with the settings
for DNS servers - see the middle tab for these settings.
DNS
When using a static IP address (i.e. when not using DHCP), specify a primary DNS server here. A sec-
ondary DNS may also be specified if desired.
LAN
The LAN interface is disabled by default, and is intended for use with future features.