HMS ATLAS TYTAN 10, Manual Instruction

Page: 30 / 58

30
STEP 12
1. Insert the 50*50 Plug(#64), 25*50 Plug(#62) ,
φ25 Plug(#59)and the U-Buffer(#74) to the end of part(#17).
2. Set the Comfort Grip(#75) to the part(#17).
3.
Slide the φ23*300 Foam(#84) onto the part(#17).
4. Insert the Long Shaft(#23) into the hole of part(#14).
5.
Attach the part(#17) to the part(#14) using (2)M10*16 Hex Bolts(#89) and (2)φ10 Big Washers(#106).
6. Screw the Pop-Pin(#35) to the part(#17).
STEP 13
CABLE LOOP DIAGRAM
After the Machine is assembled, check whether the cable is tensioned. (At correct tension, there should be a gap of 3-
5mm between the Top Plate and the Weight Stack.
If the Cable is slightly loose, adjust it by tightening the Bolt at the top of the weight stack.
If the Cable is very loose, adjust the length of Coil Chain (115), using the Snap Link (114).