User Guide | Arcadia® Central Station
l
LAN Port Assignment
l
DHCP
Enabled
/Disabled
l
IP Address (read only when DHCP is Enabled)
l
Subnet Mask (read only when DHCP is Enabled)
l
MAC Address (read only)
Push the fourth rotary to open the on screen toucnscreen keyboard to change IP and Subnet.
[
OK
] when done. The keyboard is only available when DHCP is disabled.
Note:
When changing from DHCP
Enabled
to DHCP
Disabled
, the address previously assigned by
the DHCP server will be set as the static address. This can cause IP conflicts so you must
change the address to one not provisioned by the DHCP server.
AES67 (for IP transceivers)
The section of the menu is read only and only shown if the AES67 connection has been
configured with a LAN port from the CCM. It shows:
l
LAN Port Assignment
l
DHCP Enabled/Disabled
l
IP Address
l
Subnet Mask
l
MAC Address
Dante
The section of the menu is read only and only shown if the Dante connection has been
configured with a LAN port from the CCM. It shows:
l
LAN Port Assignment
l
IP Address
l
Subnet Mask
l
MAC Address
4.4.8
Administration
l
Beltpacks
l
Over the Air: Press rotary four to
Start OTA
. Put the Arcadia Central Station in
pairing mode for OTA registration of beltpacks (600 seconds).
Page 39
Summary of Contents for Clear-Com ARCADIA Series
