HM-Funktechnik HM 2225, Installation And Operation Instruction Manual

Page: 9 / 20

9
2.2.7 Button Functionality HM2236
Button Button Functionality
Ziehen I
Ziehen II
Push lever up, winch 1 or 2
pulls in cable
K.Lösen I
K.Lösen II
Controlled brake release
(see DIL switch pos. section 4.6)
Lösen I
Lösen II
Pull lever down, brake 1 or
brake 2 is released
Gas+
The accelerator actuator pushes out
the compression pump lever
(see DIL switch pos. section 4.6)
Gas -
The accelerator actuator pulls in the
compression pump lever
Hupe Sounds the vehicle horn
Stop
switches to standby mode, when
the receiver is in the active mode
red LED will extinguish
green LED will light
2.2.8 Button Combinations HM 2236
Button Combination Combination Functionality
Hold Gas+ and
press Stop
Switches the receiver unit from standby mode to active mode,
enabling the control output voltage. The red LED will illuminate
Hold Gas– and
press Stop
Switches the receiver completely off
(please use this function only if the engine is switched off )
Hold K.Lösen and
press Gas+/-
Adjusts the brake release interval of K.Lösen
(depends on DIL-Switch 6 - see section 4.6)
Hold Hupe and
press Gas+/-
Adjusts the ON/OFF-times of the brake release interval of
K.Lösen
(depends on DIL-Switch 6 - see section 4.6)
Hold Hupe and
press Stop
Initiates an emergency alarm
(The external emergency call signal is triggered)
Hold Hupe and
press K.Lösen I
Engine Start
Hold Hupe and
press K.Lösen II
Engine Stop
Hold Hupe and
press Ziehen
Switch-over 1./2. gear of the winch in standby mode
(release Ziehen before Hupe)
Hold Ziehen and
press Hupe
Switch-over 1./2. gear of the winch during pulling
(release Ziehen before Hupe)