HM-Funktechnik HM 2225, Installation And Operation Instruction Manual

Page: 7 / 20

7
2.2.3 Button Functionality HM2226
Button Button Functionality
Ziehen I
The winch pulls in cable
(only winch 1)
K.Lösen I
Controlled brake release winch 1
(see DIL switch pos. section 4.6)
Lösen I
Brake is released
(only winch 1)
Gas+
The accelerator actuator pushes
out the compression pump lever
(see DIL switch pos. section 4.6)
Gas -
The accelerator actuator pulls in
the compression pump lever
Hupe Sounds the vehicle horn
Stop
When the receiver is in the active
mode, switches to standby mode
(see section 4.2) Red LED will
extinguish, green LED will light.
2.2.4 Button Combinations HM 2226
Button Combination Combination Functionality
Hold Gas+ and
press Stop
Switches the receiver unit from standby mode to active mode,
enabling the control output voltage. The red LED will illuminate
Hold Gas– and
press Stop
Switches the receiver completely off
(please use this function only if the engine is switched off )
Hold K.Lösen and
press Gas+/-
Adjusts the brake release interval of K.Lösen
(depends on DIL-Switch 6 - see section 4.6)
Hold Hupe and
press Gas+/-
Adjusts the ON/OFF-times of the brake release interval of
K.Lösen (depends on DIL-Switch 6 - see section 4.6)
Hold Hupe and
press Stop
Initiates an emergency alarm
(The external emergency call signal is triggered)
Hold Hupe and
press K.Lösen I
Engine Start
Hold Hupe and
press K.Lösen II
Engine Stop
Hold Hupe and
press Ziehen
Switch-over 1./2. gear of the winch in standby mode
(release Ziehen before Hupe)
Hold Ziehen and
press Hupe
Switch-over 1./2. gear of the winch during pulling
(release Ziehen before Hupe)