HKS 45003-AK005, Instruction Manual

Page: 32 / 52

−31−
３．Standard Mode
３．１．Boost Control
While the EVC is in the Standard Mode, the maximum boost is displayed and automatically
updated in the digital display (S), denoted with the P.H illumination. To reset value:
３．２．Peak Hold
(１)In the Stanards Mode, press the volume knob to set
・The EVC will beep and Ｐ．Ｈ． will illuminate; the
digital display (S) changes from peak hold display
to the blinking target boost value.
・"ＳＥＴ" will also illuminate.
・To set value for B Mode, select B Mode with the
volume knob (turn right), then press knob.
(２)Turn the volume knob to set the target boost value.
When the value is selected, press the volume knob again.
・The EVC will beep and the displays returns to peak
hold display.
・The selection range is from baseline boost to
250kPa / 36.0 PSI.
・The target boost value set in the initial setting is
the default value for booth A & B Modes.
(１)Press the volume knob for more than 1 second
・The peak hold value will cleared and reset to
0 kPa or 0.0 PSI accordingly.
Set the boost values for Ａ/Ｂ modes in the Standard Mode.
Activate the Scramble boost function by pressing Button① or the external scramble switch.
３．３．Scramble
(１)After pressing Button① or the external scramble
to trigger its activation, the EVC will.
・Beep to indicate that the function is active.
・The bar graph and "SBC" will blick and the remaining
time of the scramble will be displayed on the digital
display (S).
・When using the user preset time function of the
Scramble, the countdown does not begin until the
release of the button or external switch.
(３) To turn the EVC off, press Button ② for more than １
second. Repeat set to turn the EVC on.
・An audible beep will be emitted to confirm action.
・When the EVC is off, the current boost reading and the
Peak Hold value will be the only data displayed.
www.R33-GTR.org