7. If you want to make changes under Community, select the Community check box,
and then enter a community name or select from the list of existing community
names.
You can enter up to 180 alphanumeric characters. The following special characters
are not allowed:
"
,
\
,
;
,
:
,
,
,
*
,
?
,
<
,
>
,
|
,
/
,
^
,
&
,
'
, and
%
.
Do not use a space either at the beginning or the end.
8. If you want to make changes under Request Permitted, select the Request
Permitted check box, and then complete one of the following steps:
■
If you want to allow REQUEST operations from all managers, select the All check
box.
■
If you want to allow REQUEST operations only from specified managers, perform
one or more of the following steps:
- To enter a new IP address, select IPv4 or IPv6, and then enter the IP address.
- To use an existing IP address, select from the list of existing IP addresses.
- To add more than one IP address, click Add IP Address to add additional input
fields.
- To delete an IP address from Send Trap To, click the minus (-) button next to the
IP address.
Note: Any IP address that has all values set to zero (0) cannot be
specified for IPv4 and IPv6. The IPv6 address is specified by entering 8
hexadecimal numbers that are separated by colons (:) using a
maximum of 4 digits from zero (0) to FFFF inclusive. The default form
of the IPv6 address can be specified.
9. Click OK.
The community and IP address that you entered are changed in the Registered
Request Authentication Settings table.
10. Click Finish.
11. In the Confirm window, enter a name for the task, confirm the settings, and then
click Apply.
Changing request authentication for SNMP v3
This topic describes how to change users and authentication settings for SNMP v3
request authentication.
Before you begin
You must have the Storage Administrator (Initial Configuration) role to perform this task.
For more information, see the System Administrator Guide.
Procedure
1. Display the Device Manager - Storage Navigator main window.
2. From the Settings menu, select Environmental Setting > Edit Alert Settings.
Changing request authentication for SNMP v3
Chapter 4: Setting SNMP
Hitachi Alert Notification Guide for VSP5000 Series
33
