34
ENERGY SAVING
Setting “Energy Saving” mode
Setting the “Energy Saving” mode reduces the ability to cool each compartment for energy savings.
Likewise, when the door of the Vegetable Compartment is left open for 30 seconds or more, the LED light in the compartment has reduced brightness
for energy savings.
If a door is not opened or closed for a long time,
the inside is cooled down slowly to further reduce power consumption.
Touch
button on the Control Panel to
turn on the indicator lamp.
All indicator lamps turn on, and then the current settings are displayed.
Press and hold
for 3 seconds or more
until the preset sound (long beep) is heard to
turn on the “Save” indicator lamp.
“Energy Saving” mode is off at the time of purchase.
Touch
on the Control Panel to turn on the
indicator lamp, press and hold
for 3 seconds
or more until the preset sound (2 beeps) is heard
to turn off the “Save” indicator lamp.
1
2
3
●
Automatic temperature control lowers cooling loads, which may cause ice cream to get soft and frost to form
on frozen food. It also requires longer freezing time and ice making time.
●
When “Quick” is set in the Energy Saving mode, the Energy Saving mode is temporarily cancelled, and Temporarily cancel the
operation which weakens the cooling.
●
When the temperature of the “Refrigerator Compartment” and/or “Selectable Compartment” is set to “
■
” , the minimum level of
cooling is not reduced to maintain the freshness of foods.
Notice
Set the condensation prevention heater to MIN.
(Swing partition)
Setting the condensation prevention heater to MIN saves energy.
When dew is formed in the swing partition, set it to the standard.
The temperature settings for the swing partition can be adjusted by three levels (1 to 2), and level 2 is the most energy saving.
MIN setting of the heater
Standard
MIN setting level 1
MIN setting level 2
Standard
Preset sound
−
Long beep
Long beep (2 beeps)
2 beeps
Open the Upper Selectable Compartment door
Touch
button on the Control Panel to turn on the indicator lamp.
All indicator lamps turn on, and then the current settings are displayed.
Close the Upper Selectable Compartment door
Press and hold
button for 3 seconds or more until the preset sound is heard.
The setting of MIN level of the dew condensation prevention heater will be switched.
Repeat the above-stated operation to set it to the level you prefer (see the table above).
1
2
4
3
●
The setting will be returned to the standard when the power plug is disconnected and connected or power failure recovery takes place.
Notice
(At the time of purchase)
Swing partition
Light ON
Touch for
3 seconds
How to enable “Energy Saving”