Revision A June 27, 2011
12 / 49
5
) Error
Error (Word9) of the reply command shows the error of the housing camera.
Table 5.1 shows the content of the error.
Table 5.2 shows the generation factor and measures of the error.
Table 5.1 The content of the error.
Error Code
Content of the error
7 bits
The command is disregarded.
6 bits
Initial busy
5 bits
Camera unit failure
4 bits
Not used
3 bits
Not used
2 bits
Not used
1 bits
Not used
0 bits
The Specification date is improper.
Table 5.2 the generation factor and measures of the error.
Content of the
error
Generation factor
Measures
The command is
disregarded.
( Notes )
When the one shown in the following
was a busy, the transmission
command was transmitted
1) Initial busy
2) Lens busy
3) When camera menu opens
Please end the operation shown below or
transmit the transmission command after
operation ends.
Initial busy
Initial busy
The camera is being initialized.
It waits until initial operation ends.
Camera unit
failure
At the state of the camera unit and
communicate impossible
Please control the zoom and focus by the
Zoom/Focus command.
The Specification
date is improper.
When the parameter of the
transmitted transmission command
is outside a specified range.
The parameter is set within the range of
specification.
Notes
The command disregard is not generated in the command (one that the command title starts by
Call) that reads information.
Summary of Contents for KP-D5010-S1
Page 48: ...Revision A June 27 2011 48 49 ...
