Hitachi IC25N010ATCS04, Specifications

Page: 171 / 217

13.27 Sense Condition (F0h: vendor specific)
see below Status 1 1 1 1 0 0 0 0 Command
- - - D - - - - Device/Head 1 - 1 D - - - - Device/Head
- - - - - - - - Cylinder High - - - - - - - - Cylinder High
- - - - - - - - Cylinder Low - - - - - - - - Cylinder Low
- - - - - - - N Sector Number - - - - - - - - Sector Number
V V V V V V V V Sector Count - - - - - - - - Sector Count
see below Error 0 0 0 0 0 0 0 1 Feature
- - - - - - - - Data - - - - - - - - Data
7 6 5 4 3 2 1 0 Register 7 6 5 4 3 2 1 0 Register
Command Block Input Registers Command Block Output Registers
V - - V - V V V 0 0 V 0 V 0 0 0
ERR IDX COR DRQ DSC DF RDY BSY AMN T0N ABT 0 IDN 0 UNC CRC
0 1 2 3 4 5 6 7 0 1 2 3 4 5 6 7
Status Register Error Register
Figure 116. Sense Condition Command (F0h)
The Sense Condition command is used to sense temperature in a device. This command is executable
without spinning up even if a device is started with No Spin Up option. If this command is issued at the
temperature out of range which is specified for operating condition, the error might be returned with
IDN bit 1.
Not recommendable condition for start up. If over stressed condition is detected,
this bit will be set to one. N
Temperature is higher than 107°C FFh
Temperature is (Value/2–20)°C 01h–FEh
Temperature is equal to or lower than –20°C 00h
Description Value
The Sector Count register contains result value. Sector Count
Input parameters from the device
The Feature register must be set to 01h. All other values are rejected with
setting ABORT bit in status register. Feature
Input parameters to the device
Hitachi Travelstar 60GH & 40GN hard disk drive specifications
158