--- 26 ---
(3) Mounting Metal (C)
[24]
to Guide Sleeve (C) Ass'y
[25]
(Fig. 19)
[19]
[35]
[19]
[35]
Align the bolt hole of Blade Holder (C)
[19]
with the hole of Lever (C)
[35]
, then insert the Special Bolt M5
[34]
into the hole. Tighten the Special Bolt M5
[34]
and the Lock Nut M5
[26]
at the specified torque. Be careful not
to break Lever (C)
[35]
by overtightening. Push the Cap
[31]
to Lever (C)
[35]
from the side so that the arrow
mark on the Cap
[31]
points downward. At this time, check that there is no gap between the Cap
[31]
and
Blade Holder (C)
[19]
. Finally, mount and dismount the saw blade to check for operation.
Fig. 17
Fig. 18
Fig. 15
Fig. 16
[36]
[36]
[35]
[19]
[36]
[32]
[27]
[33]
[35]
[19]
[36]
[32]
[27]
[33]
[34]
[31]
[26]
Use the special jig (J-316) for press-fitting to control
dimensions accurately.
There is an inspection hole on one side of Metal (C)
[24]
. Insert Metal (C)
[24]
into Guide Sleeve (C) Ass'y
[25]
so that the flat portion on the outside of Metal (C)
[24]
can be seen from the 8-mm diameter hole of
Guide Sleeve (C) Ass'y
[25]
. Set the jig between the
8-mm diameter hole of Guide Sleeve (C) Ass'y
[25]
and the end surface of Metal (C)
[24]
as shown in
Fig. 19. Press-fit it in the arrow direction with a press
as far as Guide Sleeve (C) Ass'y
[25]
will go.
Fig. 19
[25]
[24]
J-316
J-316
J-316
