--- 27 ---
(4) Mounting Gear Cover (D)
[20]
(Figs. 20 and 21)
Insert the two Rubber Spacers
[28]
and two Weight Shafts (D)
[30]
into the 6.6-mm diameter holes of Gear
Cover (D)
[20]
that is mounted with Guide Sleeve (C) Ass'y
[25]
, facing the stepped ends of the Weight Shafts
(D)
[30]
forward (Gear Cover (D)
[20]
side). At this time, check that the Rubber Spacers
[28]
are securely
mounted. Mount Counter Weight (D)
[29]
to it. Then mount Second Shaft (D)
[47]
that is mounted with the
recipro plate ass'y to it so that the spherical portions of Recipro Plate (C)
[44]
and Recipro Plate (D)
[48]
fit in
the grooves of Plunger (C)
[27]
and Counter Weight (D)
[29]
. Note that the Rubber Spacers
[28]
may also
come off if Weight Shafts (D)
[30]
come off. Perform the above mounting work holding Weight Shafts (D)
[30]
in the arrow direction as shown in Fig. 20.
Insert Second Shaft (E)
[49]
that is mounted with the Gear
[50]
and the Ball Bearing 608VVC2PS2L
[51]
into
Second Shaft (D)
[47]
as shown in Fig. 21. Mount Washer (G)
[15]
and the Nut M8
[14]
to it and tighten the
Nut M8
[14]
lightly. Mount Inner Cover (D)
[52]
that is mounted with the Armature
[57]
to it. Holding the
Armature
[57]
, tighten the Nut M8
[14]
at the specified torque. Be careful not to move Weight Shafts (D)
[30]
.
Otherwise, the Rubber Spacers
[28]
may come off. Application of adhesive is permitted when mounting the
Rubber Spacers
[28]
to Weight Shafts (D)
[30]
.
Fig. 20
[30]
[20]
[29]
[44]
[28]
[47]
[48]
