Hitachi BW-80W, User Manual

Page: 55 / 60

55
The lid is not locked
completely
(The lid is not completely closed)
機蓋沒有完全鎖緊
（機蓋沒有完全關閉時）
Washing basket can
not rotate
(washing, rinsing, spinning)
洗衣槽無法旋轉
（洗衣、沖洗、脫水）
• Is there foreign substance under
the lid?
機蓋下有異物？
Troubleshooting
排除異常
Restart operation
再次 啟 動運轉
• Are the washings oblique?
衣物有無偏斜？
• Or is the washing machine placed
straight? See page 8
洗衣機是否水平放置？
8
Please press the
"START/PAUSE"
button to pause
the operation,
rearrange the
laundry evenly,
and restart with
the lid closed.
請按下暫停按鈕暫
停運轉，調整衣物
平衡後，關閉機蓋
重新
啟 動。
• If the above abnormal alarms occur, they may be caused by outside interference.
若出現上述之外的異常警報，有可能是由外來干擾導致。
• At that time, please press the PAUSE button to suspend the washing machine, then restart it. If the same alarms occur,
please stop the use and contact authorized service centre.
此時請按下暫停按鈕暫停運轉，然後重新開機，若仍出現相同的異常警報，請停止使用並聯絡日立維修服務中心。
Case
現 象
Cause
原 因
Before the repair request
Please recheck the following items
要求修理前 請再次檢查以下項目
Fail to running
不運轉
• Is power failure?
是否停電
?
• Does fuse or breaker blow?
保險絲或熔斷器是否燒斷？
• Can the power plug enter the socket properly?
電源插頭是否可靠地插入電源插座？
• Is the power switched on?
電源開關是否打開？
• Is the tap turned on?
水龍頭是否打開？
• Is the "Timer washing process" set? 46
是否設定了預校洗衣程序？
46
• Is the "START" button pressed or not?
有無按下 啟 動按鈕？
Lock of lid can not be
unlocked
機蓋緊鎖無法解除
Fail to spinning
無法脫水
• Press "PAUSE" button, and then
restart it.
按下暫停按鈕，然後重新開機。
• Is the water drainage hose properly installed?
排水管是否被正確安裝？
Refer to the solution for when 「 C 2 」 is displayed.
請參考指示燈出現「 C2 」時的處理方式。
• Check whether there is excessive foaming.
是否產生大量泡沫。
Run a rinse operation before trying to spin again.
請先執行「沖洗」後再進行脫水。
If there is still trouble,
stop using the unit
and contact autho-
rized service centre.
若仍出錯，請停止
使用並聯絡日立維
修服務中心。
DISPLAY
Alarm content
警報內容
Part to check
檢查部位
Solution
處理方法
Troubleshooting
排除異常
Restart operation
再次 啟 動運轉