Hitachi BW-80W, User Manual

Page: 58 / 60

58
Case
現 象
Cause
原 因
• The security switch acts as the laundry declines.
Change automatically to the "Water-storage rinse" for the next
rinsing.
由於衣物偏斜導致安全開關動作的緣故。
下次沖洗將自動變為儲水沖洗。
Supply water during spinning.
脫水過程中供水。
• The security switch acts as the laundry declines.
Start spinning and agitating after rinsing, and the spinning will
go on after clearing the laundry declination.
由於衣物偏斜導致安全開關動作的緣故。
沖洗後進行脫水和攪拌運轉，消除衣物偏斜後還會繼續脫水。
Supply water and start rinsing
during spinning.
脫水過程中開始供水並沖洗。
• It is because the sensor control the spinning times to improve
the efficiency of spinning.
這是為提高脫水效率，由於傳感器控制脫水次數的緣故。
Spin intermittently after
spinning starts.
脫水開始後，間歇性地脫水。
• When the power supply is cut off, the basket stops completely,
and the lid lock will be unlocked.
當斷開電源，脫水槽完全停止下來後，機蓋緊鎖將被解除。
The lid cannot be opened even
when the PAUSE button is
pressed during spinning.
脫水過程中，即使按下暫停按鈕也
無法立即打開機蓋。
• The power supply switch won't work until the basket stops the
inertial rotation.
直到脫水槽的慣性旋轉停止後，電源開關才會起作用。
The power supply switch will
not work right away even when
the ON/OFF button is pressed
during spinning.
脫水過程中即使按下電源開關按
鈕，電源開關也不會立即起作用。
About the
spinning
關於脫水
Relatively low water level com-
pared with the washings load.
水位相對於洗衣量較低。
• The setting of the water level is based on the extent of the laun -
dry emerging out the water surface and the ability of the clothes
volling up and down in the washing tub.
洗衣機以衣物稍微露出水面為依據設定水位，由葉輪攪拌衣物可以上下翻動。
• Since the clothes of chemical fiber is comparatively light, the
water level is set accordingly low.
由於化學纖維、聚脂纖維等衣物較輕，因此水位設定也較低。
About
the water
level
關於水位
About
rinsing
關於沖洗
During rinsing, water-storage
rinsing will automatically change
to water-injection rinsing, and the
rinsing time and spinning time
will become longer.
沖洗過程中，由儲水沖洗自動變為
注水沖洗，並且沖洗時間與脫水時
間都變長。
• The detergent has caused too much foam, so the washing
machine will automatically adjust.
這是由於使用的洗衣劑泡沫過多，造成洗衣機自動進行調整。
• The water level will rise during washing if the clothes being
washed have been drenched or water has been charged in
advance.
洗衣已濕透的衣物或洗衣槽中事先放了水時，洗衣時水位會較高。
• It will start operation when there is still accumulated water. To
prevent water splashing due to too much water, it may some-
times drain water.
在積水的狀態下開始運轉時，為了防止水量過多而飛濺，有時會排水。
Relatively high water level com-
pared with the washings load.
水位相對於洗衣量較高。
Midway water drainage during
washing.
洗衣的中途排水。
• If there is much floss in "NORMAL" process, the efficiency
of the floss filtering can be improved by increasing the water
consumption, extending washing time and setting rinse for
more times.
標準程序中出現較多棉絮時，可用提高水位，延長洗衣時間和設定多
次沖洗等方法提高過濾棉絮的效率。
There is much floss.
棉絮較多時
About the
lint filter
關於棉絮
過濾器
When Failure Happens (continued)
有故障發生時（續）