OPERATOR'S STATION
1-106
Controller Part Name and Function
Mode Switch (5)
Selects the air vent. The selected air vent is indicated on
monitor (7).
Air flows out of front vent and the defroster vents.
(Including defroster vent)
Air flows out of the front, rear and the defroster
vents.
(Including defroster vent)
Air flows out of the front, rear, foot and the
defroster vents.
(Including defroster vent)
Foot Vent Mode
Each time mode switch (5) is pressed, the vent location can be
changed in four stages as illustrated below.
AUTO
When switch (6) is selected in AUTO:
The air vent location is automatically selected.
Temperature Control Switch (5):
Sets temperature in the cab.
Temperature in the cab can be set from 18.0 to 32.0
°
C by
rotating temperature control switch (5). Temperature can be
set by 0.5
°
C increments.
The set temperature is displayed on monitor (7).
7
5
6
MDAA-01-001EN
MDCD-01-026
Summary of Contents for 090001
