Operator’s / Service Manual, PRS 40 EZ
© PRS 40 EZ REV A 03/16/06
190201_A
10
5.2 ANGLE
This procedure describes how to install and setup a radio angle transmitter.
CONTACT CRANE MANUFACTURER FOR WELDING INSTRUCTION PRIOR TO WELDING ON
BOOM.
Angle sensor, transmitter, and mounting plate.
The angle sensor will be mounted on the side of
boom so as the boom angle changes, the angle
sensor can rotate as shown in the 0°(left) and 90°
(above) positions.
General information
The angle sensor total range is approximately 105° and the zero point is adjustable in the software in
the angle calibration menu. With no software adjustment, the angle range will allow a -15° to 90°
range, but if the angle sensor is zeroed at -5° (-5° becomes 0°) your angle range will be -10° to 95°.
Therefore, when affixing the mounting plate to the boom, make sure you will be able to get your
desired angle range for your application.
