Hirschmann MS30, Power MICE, MACH 4000, OCTOPUS, User Manual

Page: 43 / 196

Entering the IP parameters
Layer 2 Enhanced with Layer 2 Professional
Release 1.0 10/05
2.6 System configuration via DHCP
43
2.6 System configuration via
DHCP
The DHCP (dynamic host configuration protocol) responds similarly to the
BOOTP and offers in addition the configuration of a DHCP client with a name
instead of the MAC address. For the DHCP, this name is known as the “client
identifier” in accordance with rfc 2131.
The Switch uses the name entered under
sysName
in the system group of
the MIB II as the client identifier. You can enter this system name directly via
SNMP, the Web-based management (see system dialog), or the Command
Line Interface.
On startup, an Switch receives its configuration data according to the
“BOOTP/DHCP process” flow chart
(see Fig. 13) .
The Switch sends its system name to the DHCP server. The DHCP server
can then assign an IP address as an alternative to the MAC address by using
the system name.
In addition to the IP address, the DHCP server sends
– the tftp server name (if present),
– the name of the configuration file (if present).
The Switch accepts this data as configuration parameters (see “System con-
figuration via the Web-based Interface” on page 47 ).
If an IP address was assigned by a DHCP server, it will be permanently sa-
ved locally.
Option Meaning
1
Subnet Mask
2 Time Offset
3 Router
4 Time server
12 Host Name
61 Client Identifier
66 TFTP Server Name
67 Bootfile name
Table 3: DHCP options which the Switch requests