Hirschmann MACH 1000, Reference Manual

Page: 383 / 572

CLI L2P
Release 7.0 05/2011
4.17 Port monitor
383
4.17 Port monitor
These commands show and configure the port monitor parameters.
The port monitor feature monitors certain port (or global) states or changes
and performs a certain action, when the specified condition occurs.
Using this commands, you can disable a port and send a trap (see "port ad-
min shutdown").
Disabling a port by condition will not modify the configuration and therefore
not keep the port in disabled state after reload/reboot.
To enable the action if a port state occurs
D
enable the port monitor globally,
D
enable the port monitor on the port,
D
configure condition(s) that is (are) performed in port state on a port and
D
an action that is performed on that port, when the condition complies.
The condition can be link flapping or CRC/Fragments error, an action can be
sending a trap or disabling that port (and send a trap).
If a port was disabled by the Port-Monitor the port can be enabled again with
a port monitor reset command (see “port-monitor reset”).