Hirschmann MACH 1000, Reference Manual

Page: 115 / 572

CLI Commands: Base
CLI L2P
Release 7.0 05/2011
4.6 Management Commands
115
4.6.22 show digital-output <slot/output>
This command shows the IO-Module value or configuration for a single out-
put.
Format
show digital-output <slot/output>
{all | config | value}
Mode
Global Config
all
Show the IO-Module configuration and value for one output.
config
Show the IO-Module configuration for one output.
value
Show the IO-Module value for one output.
Digital output <slot/output> Value
Show the value of the IO-Module digital output.
Possible values: Not available, High, Low, Invalid.
Digital output <slot/output> Log-Event
Show if Event logging is enabled or disabled for the IO-Module digital
output. Possible values: Disabled, Enabled.
Digital output <slot/output> SNMP-trap
Show if SNMP traps are enabled or disabled for the IO-Module digital
output. Possible values: Disabled, Enabled.
Digital Output <slot/output> Mirror from IP
Show the IP address used for reading the input value.
Possible values: Not configured, a.b.c.d (valid IP address).