Hirschmann MACH 1000, Reference Manual

Page: 130 / 572

CLI Commands: Base
130
4.6 Management Commands
CLI L2P
Release 7.0 05/2011
4.6.42 show snmpcommunity
This command displays SNMP community information. Six communities are
supported. You can add, change, or delete communities. The switch does
not have to be reset for changes to take effect.
The SNMP agent of the switch complies with SNMP Version 1 (for more
about the SNMP specification, see the SNMP RFCs). The SNMP agent
sends traps through TCP/IP to an external SNMP manager based on the
SNMP configuration (the trap receiver and other SNMP community
parameters).
Format
show snmpcommunity
Mode
Privileged EXEC
SNMP Community Name
The community string to which this entry grants access. A valid entry
is a case-sensitive alphanumeric string of up to 32 characters. Each
row of this table must contain a unique community name.
Client IP Address -
An IP address (or portion thereof) from which this device will accept
SNMP packets with the associated community. The requesting
entity's IP address is ANDed with the Subnet Mask before being com-
pared to the IP Address. Note: that if the Subnet Mask is set to
0.0.0.0, an IP Address of 0.0.0.0 matches all IP addresses. The
default value is 0.0.0.0
Client IP Mask -
A mask to be ANDed with the requesting entity's IP address before
comparison with IP Address. If the result matches with IP Address
then the address is an authenticated IP address. For example, if the
IP Address = 9.47.128.0 and the corresponding Subnet Mask =
255.255.255.0 a range of incoming IP addresses would match, i.e.
the incoming IP Address could equal 9.47.128.0 - 9.47.128.255. The
default value is 0.0.0.0
Access Mode
The access level for this community string.
Status
The status of this community access entry.