Hirschmann MACH 1000, Reference Manual

Page: 114 / 572

CLI Commands: Base
114
4.6 Management Commands
CLI L2P
Release 7.0 05/2011
4.6.21 show digital-output all
This command shows the IO-Module value or configuration for all outputs.
Format
show digital-output all {all | config | value}
Mode
Global Config
all
Show the IO-Module configuration and value for all outputs
config
Show the IO-Module configuration for all outputs.
value
Show the IO-Module value for all outputs.
Digital output Information:
output
Show numbers of the IO-Module digital output.
Possible values (example): 1/1, 1/2, 1/3, 1/4,
3/1, 3/2, 3/3, 3/4
Value
Show the value of the IO-Module digital outputs.
Possible values: Not available, High, Low.
Log-Event
Show if Event logging is enabled or disabled for the IO-Module digital
outputs. Possible values: Disabled, Enabled.
SNMP-trap
Show if SNMP traps are enabled or disabled for the IO-Module digital
outputs. Possible values: Disabled, Enabled.
Mirror from IP
Show the IP address used for reading the input value.
Possible values: None, a.b.c.d (valid IP address).
Input
Show the input number of the device used for reading the input value.
Possible values (example): 1/1, 1/2, 1/3, 1/4,
3/1, 3/2, 3/3, 3/4