Introduction
© 2009 Hirschmann Automation and Control GmbH · Branch Office Ettlingen · eMail: [email protected] · www.hirschmann.com
6
24 183 19 1012e (Generic) / 2009-02-26 / Rev. 01 / rk.
3.1 System
start
Upon switching on, the system boots and starts with an automatic test of the LMI system,
lamps and audible alarm. During the test, the LC display shows the start screen.
If the system was turned off for more than two hours, the setup configuration has to be
entered after the system test. (
⇒
chapter 4)
First, the operating mode is determined by an interactive step-by-step interrogation of the
rigging states.
Next is the interactive input of the reeving.
Now the LC display shows all inputs and awaits acknowledgment or cancelling.
Upon acknowledgment of the inputs the system is ready for operation.
In the event of a malfunction, a corresponding error code "E##" will appear on the Data
display (1). (> refer to error code table)