Hirschmann BAT-R, User Manual, Page: 34 / 70

34
Installation BAT-R
Release 09 03/2017
1.7.3 Port status
These LEDs display port-related information.
The LEDs are directly located on the ports.
WLAN2 For device variants with 2 WLAN modules:
WLAN module 2
Note:
For device variants with 1 WLAN module, this LED is unlabeled and
solely lights up after the configuration is reset (hard reset).
See “Reset button” on page 37.
P1, P2 (green/red LED) Meaning
off Connection is voltage-free.
a
a. If both connections are voltage-free, the power supply is possibly running via an active
Ethernet connection at the PoE port. The port status LEDs directly on the port show you
whether an Ethernet connection is active.
green glowing Voltage present, device is operational.
red/green flashing (slowly) Charge lock active.
b
b. Which LED displays the corresponding response depends on the configuration of the power
supply connections. P2 always performs signaling if a voltage is solely present on the
connection for supply voltage 2. In all other cases, signaling is performed by P1.
red/green flashing (quickly) Unprotected configuration as no password or the default
password is set.
a
red/off flashing (quickly) Hardware error detected.
b
red/green Running light of P1
and P2 A BAT controller WLC with an incompatible protocol is
connected.
green Running light of P1
and P2 Device is searching for a BAT controller WLC.
WLAN 1, WLAN 2
(green/red LEDs) WLAN mode Meaning
off all No WLAN network defined or WLAN module
deactivated. WLAN module does not send any
beacons.
green glowing Access Point,
P2P At least one WLAN network defined and WLAN
module activated. WLAN module sends beacons.
green flashing
inversely Access Point,
P2P Number of flashes = Number of connected WLAN
stations and P2P radio lines, then there is a break.
green flashing Access Point,
P2P DFS scanning or another scan procedure.
green flashing Client, P2P Signal strength: The faster the LED blinks, the
better the signal and thus the connection quality.
red flashing all Hardware error detected in the WLAN module.
LS/DA (green/yellow LED) Meaning
off No network device connected
green glowing Ethernet connection active
yellow flickering Data traffic
LED display elements for device status