Installation BAT-R
Release 09 03/2017
37
Connectors: type A
Supplies current of max. 500 mA
Voltage not potential-separated
1.9
Signal contact
Figure 1: Signal contact: 2-pin terminal block with screw locking
Device variants featuring supply voltage with the characteristic value C, K
or W have a signal contact exclusively.
You have the option of setting the signal contact manually using the device
management.
1.10
Reset button
The device has a reset button.
You will find more information in the “User Manual Configuration Guide”, in
the chapter “Using the Boot Configurations”.
Figure
Pin
Operation
1
VCC (VBus)
2
−
Data
3
+ Data
4
Ground (GND)
Table 7:
Pin assignment of the USB interface
1 2
4
3
Summary of Contents for BAT-R
Page 70: ......