HIRED-HAND ICS-500, Manual

Page: 8 / 34

Integrated Control System 500 6
6.1.2.1.6.OSC High Limit (Enhanced Version Only)
OUTSIDE SENSOR CONTROL
OSC
INCREASE DECREASE
(Disminuir) (Aumentar)
The Outside Sensor Control (OSC) High Limit knob allows the user to
set the temperature for the controller to go into tunnel mode. Tunnel
mode involves shutting the main curtain, opening the tunnel curtain,
and staging in tunnel fans. When temperature on the outside of the
house reaches the OSC High Limit, the controller will automatically
switch to tunnel control.
On this display, the letters "OSC" will be backlit red if the controller
has switched to tunnel mode.
6.1.2.2. Inside
To see the other controls on the System 500 Power Curtain controller, you will
need to open the panel door. These controls will be located on the large green
circuit board attached to the door of the panel.
6.1.2.2.1.Program Bank and Stages
Stages Prog Bank
A
BC
DE
F
0
1
2
345
67
8
9
A
B
CD
E
F
0
1
2
3
4 567
8
9
To change stage programming, use a
small screwdriver to select one of the
sixteen positions on the "stages" switch.
Each letter or number corresponds to a
different stage setup. These programs
are shown in the back of this manual.
The two switches shown above work together to tell the controller
which stage program to use. Each switch has sixteen positions; 0
through 9, and A through F.
To change programs, you will need to look at the program list at the
back of this manual. Look at the program name (1,0; 2,3; A,5; etc.)
The first number or letter is the program bank position; the second is
the stages position. To select that particular program, use a
screwdriver to align each of the two rotary switches to the
corresponding positions.
The system comes programmed with up to 256 stage programs. These
programs are listed in the back of this manual. Remember "Do not
change stage programs with power applied to the controller."
Disconnect power before opening controller box for any reason.