![background image](http://html1.mh-extra.com/html/hilti/pd-30/pd-30_operating-instructions-manual_2135806022.webp)
19
8. Applications
8. Applications and calculation
functions
The individual steps within all functions are
mostly supported, on principle, by graphics
on the display.
- NOTE -
– Continuous measurement can be used
within all functions where single
measurements are possible.
– If measuring errors occur during
continuous measurement or if
continuous measurement is stopped by
pressing the "Measure" key again, the last
valid distance will be shown.
8.1 Measurement data memory
While measuring, the range meter
continuously saves the measured values
and the results of calculations.
8.1.1 Saving measurements
When measuring several distances, up to
three previous distances, are displayed in
the intermediate result lines. This means
that in total the last four measured
distances are displayed or saved.
4. measured value
3. measured value
2. measured value
1. last measured
value
8.1.2 Historical data memory
The range meter saves the last five
measurements or calculation including the
graphics. Always displays immediately after
the range meter is switched On with the
On/Off-key, before any function is activated
or before the “Measure” key is pressed,
these data can be recalled from the memo-
ry and displayed one by one using the
“Plus / Minus” key.
The symbol “Historical data mode active”
shows the data stored in the memory.
Example of the display of a saved volume
measurement:
8.2 Area measurement
Areas can be determined easily and quickly.
Press the "Area" function key. This switches
the laser beam on – ready for measuring.
The individual steps for determining an
area are supported by a corresponding
graphic display. To determine the floor
space of a room, for example, the following
procedure must be followed:
a
b
= a . b
Printed: 07.07.2013 | Doc-Nr: PUB / 5070011 / 000 / 00