Hilti PD 30, Operating Instructions Manual

Page: 8 / 30

5
3. Tools and accessories
3. Tools and accessories
Description Designation
Target plate PDA 50
Hand strap PDA 60
Soft pouch PDA 61
Belt clip PDA 62
Measuring extension PDA 70
Charging kit PDA 80
Charging kit PDA 81
Mains adaptor PDAW 80-1
Mains adaptor PDAW 81-1
Car battery plug PDAW 80/81-2
Charging adaptor PDAW 80/81-1
Battery pack PDAW 80/81-3
Laser visibility glasses* PUA 60
* These are not laser safety
glasses and do not protect the
eyes from laser radiation. The
laser visibility glasses restrict
colour vision. Therefore these
are not permitted to be worn
by a person driving on a public
road, and must not be used
look straight into the sun.
3.1 PDA 50 target plate
The PDA 50 target plate is made of durable
plastic with a special reflective coating. In
poor light conditions, it is advisable to use
the target plate for distances above 10 m
(30 ft).
- NOTE -
– For reliable distance measurements the
laser beam should be perpendicular to
the target plate whenever possible. If this
not the case, the laser spot on the target
plate may not be in the same plane as
the target point and the distance
measured will be incorrect.
– For very accurate measurements using
the target plate, 1.2 mm (1/20 inch)
should be added to the measured
distances.
3.2 PDA 80 / 81 charging kits
The PDA 80 and PDA 81 charging kits
enables the use of the range meters with
rechargeable cells. The battery charging
time takes approx.12 hours for empty cells.
However, sufficient current is charged
within the first 15 minutes – for 150 - 200
measurements.
Please also refer to the description of
battery charging in section 6. Getting started.
Contents of PDA 80 charging kit
– Mains adaptor 100 – 240 V AC
with 2-pole Europlug
– Car battery plug
– Charging adaptor for range meter
– 2 chargeable battery cells (NiMH)
Contents of PDA 81 charging kit
– Mains adaptor 100 – 240 V AC
with 4 interchangeable plugs for US,
GB, AUS, EU.
– Car battery plug
– Charging adaptor for range meter
– 2 chargeable battery cells (NiMH)
3.3 PDAW 80-1 mains adaptor
The mains adaptor is an integral part of the
charging kit. It is equipped with a two pin
plug. The mains adaptor transforms the
power supply from alternating current to
direct current which is used to charge the
batteries. The mains adaptor automatically
adjusts itself to suit an AC voltage between
100 - 240 V and 50 - 60 Hz. The mains
Printed: 07.07.2013 | Doc-Nr: PUB / 5070011 / 000 / 00