Hilti DST WRC-CA, Manual

Page: 10 / 24

8 English 2053441
*2053441*
After you switch on the remote control unit, in order to start the first advance you have to turn the
control knob clockwise at the same time as you operate the joystick.
3.6 Control knob
The control knob enables you to select the following functions:
• Set drive parameters.
• Select a preset or set a value in the "Settings"".
If a value can be selected or set by turning the control knob, the control knob symbol
appears alongside
the value or the selectable settings.
3.7 EMERGENCY STOP
It is permissible to enter the danger zone after the EMERGENCY STOP button has been pressed.
3.8 Buttons/keys on the remote control unit
ON/OFF
When the button is pressed it lights up green and the Home screen appears on the display. The
remote control unit is ready for use.
To switch off, press and hold down until the display goes blank and the green light goes out.
DRIVE ON / OFF
When the button is pressed it lights up green and the drive starts. Short-press to switch off.
HOME
Shows the Home screen.
3.9 Function buttons
The buttons on the left and right of the display are function keys of the screen-labeled softkey type. The
function assigned to each softkey at any given time is indicated by the corresponding symbol that appears
on the display.
3.10 Parameter settings <...>
Mains fuse rating Cutting parameters
Saw blade diameter Automatic cooling water control
Password Country, language, unit of measurement
Date and time Display brightness
Messages System information
Logbook Service indicator
3.11 Functions <<...>>
Settings Settings with the control knob
Printed: 28.02.2018 | Doc-Nr: PUB / 5200714 / 000 / 03