Parts
No.
Designation
Blade guard center section
Blade guard side section
Guide pin
Blade guard holder
Guide rollers
Clamp
Tensioning lug
Rubber tensioning strap
Assembly
22
Fitting the blade guard
-NOTE-
■
Should it prove impossible to use the blade guard due
to specific circumstances at the working area, spe-
cial measures must be taken, such as construction
of a temporary enclosure (e.g. using forming boards),
to protect the surrounding area from flying fragments
etc. while sawing.
■
Use the DS-FCA flush-cutting flange and flush-cut-
ting blade guard (available as accessories) for flush-
cutting applications.
-CAUTION-
Remove the side section only immediately before begin-
ning a corner cut.
1. Push the center section of the blade guard
, or the
complete blade guard, onto the blade guard holder
.
2. Insert the 2 side section locking hooks
in the fit-
ting of the blade guard center section
, attach the
clamp
of the side sections to the middle section
and secure blade guard to blade guard holder with
rubber strap
onto the tensioning lug
.
3. To remove the side section open clamp
and lift it
out of middle section.
4.15
Printed: 08.07.2013 | Doc-Nr: PUB / 5069686 / 000 / 01
