Adjusting the blade guard
1. Release the clamping screw
on the saw arm.
2. Pivot the blade guard holder
into the desired posi-
tion.
3. Tighten the clamping screw
.
4.12
Parts
No.
Designation
Blade guard holder
Clamping screw
Hex. head wrench, 8 mm AF
Connecting the power cable, remote control unit
and cooling water hose to the power supply and
saw head
-CAUTION-
■
To avoid damage to the parts, check that the plug and
socket are clean and in good condition before con-
necting. Clean the parts or remedy any damage before
connecting them.
■
When unplugging, always grip the plug and not the
cable. Fit the protective cap immediately.
■
Do not use the plug as a grip or carrying handle.
■
Do not allow the cables to become tangled and place
them carefully so that the plug connectors are not
lying in water. The cables must be long enough to
allow the saw head to move freely.
1. Remove the protective caps.
2. Align the plug carefully with the socket and push it in
all the way without using excessive force.
3. Close the securing sleeve and check that it engages.
4. Close the protective caps together.
5. Connect the cooling water hose.
4.13
Parts
No.
Designation
Power cable plug / socket
Control cable plug / socket
Cooling water hose connectors
Protective cap
Securing sleeve
Assembly
20
Printed: 08.07.2013 | Doc-Nr: PUB / 5069686 / 000 / 01
