10
Other information
In these operating instructions, the DS TS20-E electric
wall saw is referred to as
“the machine”
.
Location of identifying data on the machine
The type designation, item number, serial number, year
of manufacture and technical status can be found on the
rating plate on the machine.
Make a note of this data in your operating instructions
and always refer to it when making an enquiry to your
Hilti representative or service department.
Power supply:
Type: DS EB-TS20
serial no.
Saw head:
Type: DS TS20-E
serial no.
Remote control unit:
Type: DS RC-TS20
serial no.
Disposal of drilling and sawing slurry
■
With regard to environmental aspects, allowing drilling
or sawing slurry to flow directly into rivers, lakes or
the sewerage system without suitable pre-treatment
is problematical.
■
In addition to the following recommended pre-treat-
ment procedures, the applicable national regulations
must be observed when disposing of drilling or saw-
ing slurry. Ask the local authorities concerned for fur-
ther information.
We recommend the following pre-treatment
■
Collect the drilling and sawing slurry (e.g. using a suit-
able industrial vacuum cleaner).
■
The fine content of the drilling and sawing slurry should
be separated from the water by allowing it to settle
(e.g. leave standing for some time or add a coagula-
tion agent).
2.9
2.8
■
Solid material from the drilling and sawing slurry
should be deposited at a construction waste
■
Water from the drilling and sawing slurry should be
neutralized (e.g. by adding a large quantity of water
or other neutralization agents) before it is allowed to
flow into the sewerage system.
Specific safety rules and symbols
Printed: 08.07.2013 | Doc-Nr: PUB / 5069686 / 000 / 01
