![background image](http://html1.mh-extra.com/html/hilti/d-lp-32/d-lp-32_operating-instructions-manual_2135192030.webp)
30
Mounting D-R..L rails, clamping piece and rail
extension
■
D-R...L rails are available in 50, 100, 150, 200 and
230 cm lengths
■
Use the D-CP-M/L clamping piece when the rail is
mounted vertically. Attach the clamping piece to the D-
R..L rail and hook it into the upper, previously aligned
and levelled DS-RF rail support.
■
Position the lower end of the rail in the lower rail sup-
port (not yet fully tightened), slide up the clamping plate
and tighten the M12 screw. Check the distance from
the cutting line and alignment of the rail before fully
tightening the screw
➋
■
When mounting the rails, always position the rail sup-
port at right angles to the rail and then tighten all rail
fastening screws securely.
■
All Hilti D-R..L rails can be extended to form a rigid unit
by using a D-C-O-ML double taper and D-EP-ML eccen-
tric pin.
■
The recommended distance between rail supports is
approx. 1.5 m.
■
When a double taper is not available for use, rails can
be extended by mounting a rail support at the joint
between two rails. In this case, use a DS-ES-L end stop
to set the correct distance between rail sections.
6.2.3
■
D-R..L rails are also used as the column in the
DD-750 HY hydraulic drilling system.
■
Fit the end stop after mounting the rail.
1
2
DS-RF
rail support
Clamping
plate with
M 12 screw
(19 mm AF)
Rail support with
clamping plate
Attach the clamping piece
D-CO-ML double taper
D-EP-ML eccentric pin
D-CP-ML clamping piece
DS-ES-L end stop
6. Before use
Use a D-CO-ML double
taper to extend rails or
position a DS-RF rail sup-
port at the joint between
the rails.
DS-ES-L
DS-RF
DS-RF
DS-ES-L
Printed: 08.07.2013 | Doc-Nr: PUB / 5069667 / 000 / 01
Summary of Contents for D-LP 32
