![background image](http://html1.mh-extra.com/html/hilti/d-lp-32/d-lp-32_operating-instructions-manual_2135192029.webp)
29
6. Before use
Setting up the saw system
Securing to the base material
■
The saw system can be used efficiently and safely only
when anchored rigidly and securely to the base mate-
rial. We recommend use of Hilti drilling machines and
anchor systems.
■
The rail supports and angular cutting plates must be
secured with anchors suitable for the base material.
WARNING
Use an anchor suitable for the material on which you
are working and observe the anchor manufacturer’s
instructions.
NOTE
Hilti M12 metal expansion anchors are usually suitable
for fastening diamond core drilling equipment to uncracked
concrete. Under certain conditions it may be necessary
to use an alternative fastening method. Please contact
Hilti Technical Service if you have any questions about
secure fastening.
■
When placing the Hilti HKD M12 metal expansion anchor,
for example, a minimum distance of 20 cm to the near-
est edge must be observed. The dust must be blown
out of the holes and the anchors set approx. 5 mm below
the surface of the concrete.
■
On masonry, etc., for example, Hilti HIT adhesive anchors
or through rods may be used.
■
On extremely uneven surfaces, suitable shims or pack-
ing pieces must be positioned beneath the rail supports
where necessary, or the rail support adjustment screws
adjusted accordingly.
■
The most frequently used anchor on reinforced con-
crete:
Recommended by Hilti:
HKD-D M 12
×
50, d 16
The use of galvanised screws is recommended.
approx. 5 mm
d
m
m
washer
M 12
×
40 screw
8.8. grade
6.2
6.2.1
Positioning the rail supports for
standard cuts
DS-TS32 main dimensions and distance
from the kerf (mm):
Beispiel: Türöffnung sägen
Example: Sawing out a door opening
6.2.2
5
23
5
230
139 Distance from line ocut
23
5
27
5
Possible
dividing cut
Floor
Width of kerf
y
Align upper
rail support
precisely,
level
and tighten.
x
Align lower
rail support
and tighten
slightly.
230
Printed: 08.07.2013 | Doc-Nr: PUB / 5069667 / 000 / 01
Summary of Contents for D-LP 32
