41
7. Operation
Dismantling the saw system
■
Secure the block of concrete you have cut. Use steel
wedges when necessary.
■
Clean the equipment by spraying with water. Dry the
parts with a cloth.
■
Remove the blade guard, blade and other modules (fol-
lowing assembly instructions but in reverse order).
■
Secure the concrete block(s) or withdraw them care-
fully from the hole and make arrangements for their
transport.
■
Cordon off the opening so that it presents no hazard
to third parties.
7.4
7.3.5
Operating the D-LP 32 with 2-speed gear DS-TS 30 (previous model), selecting the gear, guide values,
sawing procedure, saw blades for the 2-speed gear D-LP 32/DS-TS 30 hydraulic saw system
Optimum saw blade cutting speed (peripheral speed): A guide value of approx. 40 m/sec. is recommended by most saw
blade manufacturers, including Hilti. Depending on the situation (concrete quality, aggregates, steel content, etc.), speeds
of between 30 and 50 m/sec. can be used.
®
Guidelines for D-LP 32 with 2-speed gear DS-TS 30
D-LP 32 / DS-TS 30 in 1
st gear
1st gear:
800–1600 dia.
35
67
49
/2
D-LP 32 / DS-TS 30 in 2nd gear
D-LP 32 / DS-TS 30/WSS 30 in 1st gear
32–63 Ampere
80–100 l/min.
D-RC-LP 32
Start
Ampere
II
I
32
63
45
100
1600 1200 1000 900 800
mm
60
40
80
32–63 Ampere
80–100 l/min.
D-RC-LP 32
Start
Ampere
II
I
32
63
45
100
1600 1200 1000 900 800
mm
60
40
80
45–50 Ampere
100 l/min
D-RC-LP 32
Start
Ampere
II
I
32
63
45
100
1600 1200 1000 900 800
mm
60
40
80
All settings same as
for
D-LP 32 / DS-TS 32
1st gear: 500 dia.
drive wheel
All settings same as
for
D-LP 32 / DS-TS 32
1st gear: 700–750 dia.
Actual dia.
Diameter settings
on remote control unit
700
Corresponds to
800 dia.
750
Corresponds to 800 dia.
2nd gear: 600 dia.
Actual dia.
Diameter settings
on remote control unit
600
Corresponds to 1600 dia.
Printed: 08.07.2013 | Doc-Nr: PUB / 5069667 / 000 / 01
Summary of Contents for D-LP 32
