![background image](http://html1.mh-extra.com/html/hilti/bx-3-me/bx-3-me_operating-manual_2135885010.webp)
8
English
@
Nosepiece
;
Fastener guide X-FG B3-ME
=
Fastener guide X-FG B3-IF
%
Fastener guide locking mechanism
&
Single-nail selector switch
(
Air vents
)
Belt hook
+
Scaffold hook
§
Safety trigger
/
Grip
:
Release buttons
∙
Charge state indicator
$
Liion battery
£
Nail pusher, locked position
|
Nail pusher release mechanism
¡
Support leg
Q
Magazine
W
Status indicator
E
On/off button
R
Nail pusher, unlocked position
3.2 Intended use
The product is a hand-held, cordless fastening tool for indoor use. It is designed to drive
specially manufactured fasteners (nails) into concrete, steel, masonry, sand-lime block
and other materials suitable for use of the direct fastening technique. The product is also
designed to fasten electrical cables with clips if the appropriate fasteners are used. Use
only approved fasteners in combination with their corresponding fastener guide (see the
section headed "Technical data").
The fastening tool, battery and fasteners together form a technical entity. This means that
trouble-free fastening with this fastening tool can be ensured only when the
Hilti
fasteners
and chargers and batteries recommended by
Hilti
are used. The fastening and application
recommendations made by
Hilti
apply only when these conditions are observed.
▶
The fastening tool is for hand-held use only.
▶
Misuse of the fastening tool must be ruled out. Misuse of the fastening tool includes
triggering in single-fastener mode without a nail inserted in the fastener guide, driving
nails into very soft materials (e.g. wood), driving single nails when the tool is set
to magazine operation, and driving nails into materials that are too hard (e.g. high-
strength steel or very hard natural stone).
▶
Use only
Hilti
Liion batteries of the B 22 series with this product.
▶
Use only
Hilti
battery chargers of the C 4/36 series to charge these batteries.
3.3 Safety devices
In magazine mode, the nail detector prevents triggering without a nail loaded, which
could damage the fastening tool.
The contact pressure safety device is intended to prevent the free flighting of nails (i.e.
actuation and driving a nail when the nosepiece is not in contact with the workpiece). In
magazine mode, the fastening tool can be pressed against the surface and triggered only
when a nail is loaded in the tool.
To use the tool in single-fastener mode, you have to press the single-fastener mode
switch before pressing the fastening tool against the working surface.
3.4 Features
The fastening tool has an ergonomic, non-slip, vibration-absorbing grip and a support
leg. The tool is protected from overloading by electronic overload protection and from
overheating by temperature monitoring.
Printed: 04.10.2017 | Doc-Nr: PUB / 5377202 / 000 / 01
Summary of Contents for BX 3-ME
Page 1: ...BX 3 ME English Printed 04 10 2017 Doc Nr PUB 5377202 000 01 ...
Page 2: ...Printed 04 10 2017 Doc Nr PUB 5377202 000 01 ...
Page 9: ...English 7 3 Description 3 1 Product overview Printed 04 10 2017 Doc Nr PUB 5377202 000 01 ...
Page 23: ...Printed 04 10 2017 Doc Nr PUB 5377202 000 01 ...